New Tracks Laid

Finally, after what seems like ages, all the new track has been laid, positioned properly and glued to the baseboards.


The curve at this end of the platforms was quite critical to get right, and the signal you see on the left had to be moved out so nothing hit it…

This will all need ballasting in due course.

The village has been tidied up but more will need to be done once the level crossing is finished and the platforms rebuilt.


 

Level Crossing Rebuilding

As part of the new track installation, the intention is to have the gates of the level crossing driven by servo motors, and a rough prototype was  constructed to test this:

The next stage was to work out how fix the level crossing, gates, servos and rails on a removable plate, as the mechanics are far too complex to work on under the layout…

A suitable hole was cut in the baseboard:

This double sided glass fibre board has the rails soldered on, and will have the gates mounted on top, with the servos underneath.
Plastic card will cover most of this and make it look more like a road:

The main tracks were then soldered to fixed copper strips each side of the level crossing board, keeping the alignment with the removable part correct.
The covers nicely hide the soldering!

Once this track was in place, new track could be laid towards the Country Station – this has not yet been fixed down:
And track laid (but not fixed down) for the halt platforms:
The track at the town end of the platforms still needs to be joined to the rest of the layout – a project for later.

 

Country End Rebuild

New points for the country end of the layout have been made from the reclaimed points:
and point motors added underneath:
The old track and points have been stripped from the country end of the layout:
Once the holes for the new points were cut (a messy job!), the area was sprayed with primer and the new points laid:
Unfortunately, a couple of point motors ended up across a strut, and an extension arm had to be installed to connect the motor to the point blade (on the right in this photo):

Goods Yard Rebuilt

Once all the points for the goods yard were made and fitted, it was time to rebuild the Goods Yard itself. The first job was to remove all the old track and ballast (the holes in the baseboard were for the old point motors):

New cork sheet was fitted, then sprayed to give a background colour:

The points were fitted first:

Then new (reclaimed) track fitted:

It was difficult getting the sleeper spacing right, so I made a crude jig from cardboard. This also helped when I was jointing lengths of track:

Once all the track was fitted, it had another quick paint spray, the after a cleanup, it was ready for use:

The buildings were also replaced:

And finally, the stock could be brought back:


The whole area will need finishing off, but that can wait until I’ve updated the track on the rest of the layout.

 

Point 21a

As time permits, I’ve been mounting and fitting points to the Goods Yard area. However, there was a problem with the last point to be made – the motor had to go where there was a strut and a bunch of wires under the layout.

So a bit of inventive thinking came up with this:

The motor drives the right hand side of the shiny copperclad bar, which pivots on the bolt in the middle, and the tie bar is driven via a pin on the left hand side.

So the left part will fit in a channel in the 9mm baseboard.

This is the top of the point, ready for installing in the layout:

You can see the pivot bolt; this will eventually be covered by ballast.