As time permits, I’ve been mounting and fitting points to the Goods Yard area. However, there was a problem with the last point to be made – the motor had to go where there was a strut and a bunch of wires under the layout.
So a bit of inventive thinking came up with this:
The motor drives the right hand side of the shiny copperclad bar, which pivots on the bolt in the middle, and the tie bar is driven via a pin on the left hand side.
So the left part will fit in a channel in the 9mm baseboard.
This is the top of the point, ready for installing in the layout:
You can see the pivot bolt; this will eventually be covered by ballast.